Controller Configuration
Advantage Megatron
How to Configure the Network Settings of the controller:
1 Press the SETUP/RUN button on the MegaTron keypad.
2. Press button #7 (CONFIGURE).
3. Press button #8 (NETWORK).
4. Press button #5 (SETTINGS).
5. Press button #9 (DHCP) and make sure it is set to “DISABLED”.
6. Press button # 5 (SETTINGS).
7. Press button #1 (IP ADDRESS) and enter the IP address 192.168.50.5
Note: Use the number keys to enter numerical values, press the right arrow key to advance to the next number position, and use the up & down arrows to scroll through the special characters to locate the decimal key.
8. Press the ENTER button to save the IP address.
9. Repeat this process for the IP MASK 255.255.255.0 and GATEWAY 192.168.50.1.
10. Once all required network settings have been entered, press the “BACK” button on the MegaTron keypad and then press button #10 (RESET). The MegaTron communications card will update and apply the new network settings.
11. Attach the supplied external antennas and provide power to the modem.
12. Connect the modem to your controller with the supplied Ethernet cable.
13. Connect to the controller remotely through WebAdvantage.