Skip to main content
All CollectionsConnectivity Guides
GW-HGAP-50 and GW-HGAP-100 Spec Sheet - Modem Antenna
GW-HGAP-50 and GW-HGAP-100 Spec Sheet - Modem Antenna
Updated over 3 weeks ago

Features:

  • Compatibility: GPS, 2.4GHz WiFi, and 700-2500mhz cellular networks, which are used by most 4G providers in the USA, including:

    • Verizon 4G/AWS

    • Sprint 4G LTE

    • AT&T 4G/LTE

    • T-Mobile 4G

    • MetroPCS 4G

    • US Cellular 4G

    • For other carriers, confirm which frequency your provider is using and make sure this antenna supports it before purchasing! Contact us if you need any assistance.

  • Height: 3.3" tall.

  • Cable: Various lengths are available; please ask for 50 or 100 feet with your quote request.

  • Ground Plane: Metal ground plane required.

  • Weatherproof? Yes, this antenna is designed for exterior use.

  • Mounting Requirements: The cable and antenna combo comes with a mounting bracket.

  • Portability: This antenna is designed to be permanently mounted and is not portable.

Specifications:

  • Model: TRA6927M3PB-001

  • Frequency Range: 698-806/806-896/890-960/1575.42/1710-1880/1710-1880/1850-1990/1900-2170/2110-2155/2400-2500MHz

  • Antenna gain:

    • 698-806MHz: 3.5 dBi

    • 806-896MHz: 5.9dBi

    • 890-960MHz: 5.8dBi

    • 1575.42MHz: 5.1dBi

    • 1710-1880MHz: 4.2dBi

    • 1850-1990MHz: 4.2dBi

    • 1900-2170Mhz: 4.4dBi

    • 2.4-2.5GHz: 3.0dBi

  • Impedance: 50ohm

  • Dimensions: 3.3” x 1.44”

  • Connector: N Female

  • Mount: Mounts thru metal surface

  • Polarization: Cross polarized

  • Radiation: Omni-directional

  • Color: Black

    Cables

  • The 50 Foot Ultra Low Loss IP67 Rated Cable has an N/Male connector on one side and an SMA/Male connector on the other side. It is typically used to connect an antenna with a N/Female connector to a router or amplifier with an SMA/Female connector.

    Specifications:

    • Cable length: 50'

    • Connectors: N/Male & SMA/Male

    • Cable diameter: 7/16"

    • Impedance: 50ohms

    Signal Loss:

    • The amount of signal attenuation you'll see depends on which frequency you're using.

    • This cable averages approximately 2.5dB of signal loss.

    • The attenuation for each frequency is below:​

      • 700mhz: 1.7dB

      • 800mhz: 1.8dB

      • 1700mhz: 2.7dB

      • 1900mhz: 2.9dB

      • 2100mhz: 3.1dB

      • 2400mhz: 3.3dB

      • 2500mhz: 3.4dB

    • Approximately .5dbm is lost at each connection between 2 cables

    To prevent excessive signal loss, this cable should NOT be daisy chained with other cables! It is always better to use one longer piece of cable than to screw two shorter cables together.
    ​


    ​The 100 Foot Ultra Low Loss IP67 Rated Cable has an N/Male connector on one side and an SMA/Male connector on the other side. It is typically used to connect an antenna with an N/Female connector to a router or amplifier with an SMA/Female connector.

    Specifications:

    • Cable length: 100 Foot

    • Connectors: N/Male & SMA/Male

    • Cable diameter: 7/16"

    • Impedance: 50ohms

    Signal Loss:

    • The amount of signal attenuation you'll see depends on which frequency you're using.

    • This cable averages approximately 5dB of signal loss.

    • The attenuation for each frequency is below:​

      • 700mhz: 3.4dB

      • 800mhz: 3.7dB

      • 1700mhz: 5.5dB

      • 1900mhz: 5.8dB

      • 2100mhz: 6.2dB

      • 2400mhz: 6.6dB

      • 2500mhz: 6.8dB

    • Approximately .5dbm is lost at each connection between 2 cables

    To prevent excessive signal loss, this cable should NOT be daisy chained with other cables! It is always better to use one longer piece of cable than to screw two shorter cables together.
    ​
    ​


    ​

Did this answer your question?